| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Park Assist/Monitoring | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002CK1005X |
| Title: PARK ASSIST / MONITORING: INTUITIVE PARKING ASSIST SYSTEM: WIRING DIAGRAM (2008 Sequoia) | ||
|
Taillight Relay Circuit |
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
CHECK TAILLIGHT |
(a) Turn the light control switch to the TAIL position.
(b) Check that the taillight turns on.
OK:
Taillight turns on.
|
|
2. |
CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND) |
|
(a) Disconnect the H43 clearance warning ECU connector. |
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
H43-11 (TL) - Body ground |
Ignition switch ON, light control switch TAIL |
7 V or higher |
|
Ignition switch ON, light control switch except TAIL |
Below 1.5 V |
(c) Reconnect the clearance warning ECU connector.
|
|
|